Home > Automotive > Toyota

2007 Toyota FJ Cruiser, 4.0L split dual exit aft-cat system



09/28/06 1 2007 Toyota FJ Cruiser, 4.0L split dual exit aft-cat system 40685 /BX40685 FOR TECHNICAL ASSISTANCE CALL TOLL-FREE (866) 782-3283 2900 East La Jolla    Anaheim, CA    92806                       Parts List and Description Hardware List (A)   PN40675IP-inlet pipe (2) 3/8" urethane hangers (B)   PN51020222-muffler (5x10x20) (2) 10mm x 1.25 x 60mm bolts (C)   PN40675TA-tailpipe section "A" (2) 10mm flat washers (D)   PN40685TB-tailpipe section "B" (4) 8mm x 1.25 x 22mm bolts (E) PN40675TC-tailpipe section "C" (4) 8mm flat washers (F) PN40685RH-right side hanger bracket (2) 2.5" band clamps (G) PN40685LH-left side hanger bracket (1) 2.25" band clamp (1)       anti-seize compound Installation instructions: 1. Raise vehicle. 2. Lubricate all factory hangers with penetrating oil or equivalent. 3. Remove factory rubber hanger from hanger rod near tip of tailpipe. 4. Remove bolts attaching flange on tailpipe to flange on muffler outlet pipe and then remove tailpipe from vehicle. 5. Remove bolts attaching muffler inlet pipe to factory Y-pipe. 6. Remove factory rubber hangers from rods on muffler inlet pipe and then remove muffler assembly from vehicle. 7. Attach supplied inlet pipe to factory Y-pipe with supplied 10mm bolts and washers. Insert hanger rods on inlet pipe into corresponding rubber frame hangers. 8. Place one supplied 2.5"clamp on inlet of muffler and then install muffler onto inlet pipe. 9. Attach flange on tailpipe "A" to flange on rear of muffler with supplied 3/8" hardware. 10. Insert hanger rods on tailpipe "A" into corresponding factory rubber hangers. Continued on next page. Note: anti-seize should be applied to all fastener threads, pipe slip joints and mati ...
Download 2007 Toyota FJ Cruiser, 4.0L split dual exit aft-cat system







Related Manuals:


Most people are coming to this page searching for: