Home > Automotive > Toyota

2007 Toyota FJ Cruiser



I n s t a l l a t i o n ➤ F o r T e c h n i c i a n s O n l y A. Windshield Preparation 1. Cover the front seats, floorboards, dash and steering wheel with a clean drop cloth or disposable plastic covers. Note: Always wear eye and hand protection when working with glass. Make sure you have the right glass and that the urethane      systems are current. Windshield part number is FW02652GTY. 2. Remove the windshield-wiper nut covers using a hook tool, small flat-tip screwdriver, pick or No. 2 PryBaby. 3. Remove the nuts using a wrench or socket. If the nuts are tight, loosen them with a 15-millimeter wrench and then come back with your socket. Move the wiper arm in an up-and-down motion to break it loose from the post. 4. Tag wipers with painters tape and a marker to ensure proper installation. 5. Remove the antenna with an antenna-removal tool. 6. Tape the hood, cowl, A-pillar and fender with molding- retention tape to avoid gnarling or scratching the cowling and moldings during removal. 7. Using a No. 2 PryBaby, pop loose the two corner cowling- cover fasteners located at the base of the cowling cover at the fender near the A-pillar. Pop loose the two corner cowling- cover fasteners at the junction of the upper cowl and corner cowl.  Be careful; they break easily. A1 A2 A3 A5 A6 A4 2007 Toyota FJ Cruiser By Gilbert R. Gutierrez Vehicle type: Four-door utility vehicle NAGS® numbers*: Windshield part number FW02652GTY; front door glass FD23053-54GTY R-L; rear door glass FD23055-56GTN or YPN, R-L; quarter glass FQ23057-58GTN or YPN R-L; and back glass FB23059GTY or YPY Helpful tools or supplies: Retention tape to protect the fenders,     hood and doorframe trim; a PryBaby for molding and panel removal; two temporary universal windshield gravity stops; a leak detector; two 2-inch-by-3⁄ 8 -inch strips of 3M ...
Download 2007 Toyota FJ Cruiser







Related Manuals:


Most people are coming to this page searching for: