ManualSpace

Specialized High Performance Accessories for your Dodge/Jeep, Ford, and GM Vehicles SpeedTweaks - Tips and Tricks (Dodge) How to Reset the PCM • Disconnect NEG Battery Terminal • Turn the ignition key to the START position and hold for 15-20 seconds • Release key (OFF) and reconnect the battery When should I reset the PCM? If you change items such as the Throttle Body, Headers, Ignition System (or any internal parts with aftermarket, performance parts), then you should reset the PCM.  Items such as: Plug Wires, Cap, Rotor, Spark Plugs, Muffler, and Air Filter (not intake.filter)  dont require this at all. The PCM will gradually relearn as you drive anyway.that takes about 200 miles for a complete long-term learn. How to Clean the IAC Solenoid This is recommended at every Tune-Up to prevent excess carbon buildup on the IAC plunger.  In some cases, youll notice a slightly erratic idle quality.  This is the first step in taking care of that problem.  IAC = Intake Air Control (Solenoid). • Remove the Air Hat from the Throttle Body • Disconnect the sensor harness from the IAC Solenoid (Rear of Throttle Body) • Remove the two Torx-25 Screws • Remove the IAC Solenoid (Be careful not to lose the rubber O-Ring) • Spray some Carb/TB Cleaner in the IAC port on the Throttle Body and let it sit • Spray some Carb/TB Cleaner on the tip of the IAC Solenoid and wipe clean (Do NOT forcefully twist or push the plunger - You will damage the Solenoid.  Wipe very gently.) • Spray a little bit more Carb/TB Cleaner in the IAC port on the Throttle Body and wipe clean with a thin/lint-free rag • Reinstall the IAC Solenoid (Make sure you dont lose the rubber gasket on the solenoid) • Reinstall the sensor connector and airhat • Start the engine and let idle for about 1 minute. How to clean your Throttle Body Most people think that cleaning the throttle body requires a can of Carb/Thr ...
Host: www.bionicdodge.com

 

Download Dodge Tips and Tricks