ManualSpace

Installation Instructions for FORD FOCUS Tools & Materials Needed: 1. Utility Knife 2. Wire Crimper 3. Torxâ„¢ Wrenches 4. Hex Nut Drivers 5. Drill and Bits 6. Phillips Head Screw Driver 7. Crank Spring Removal Tool (Special Tool, available at most Auto Parts Stores) - or - 8. Flat Screw Drivers (2) 9. Add-A-Circuit â„¢ fuse adapter 10. Silicon Sealant (Clear or Black) Procedure: (Approximate time to complete installation: 3 - 4 hours) A. Removing the Door Panel Coverings 1. For ease of installation,  do both sides at the same time. 2. Roll the windows to approximately 1/2 open, and so the crank handle is in the Down Position.  With either the Crank Spring Removal Tool, or a flat Screwdriver, remove the spring, located in a slot on the back of the crank. 3. Remove the cover plate for the remote-control mirror, which is held in place by 3 spring clips.  Remove by gently pulling the front corner of the cover out, and then slide the cover back. 4. Remove the door Pull-handle cover, by inserting a screwdriver into the access hole on the bottom of the handle, and using the screwdriver as a lever, pop off the handle cover. 5. Remove the button covering a retaining screw in the interior door latch backing plate. 6. Remove the 8 Torxâ„¢ retaining screws around the perimeter of the door panel, and the single Torxâ„¢ retaining screw in the interior door latch. 7. Remove the 2 hex bolts in the door handle. 8. Gently lift the panel upwards, to disengage the window weather-strip molding. 9. Remove the Door Latch Trim Panel, be sure to unplug the Power Lock Switch, and remember how the wire was run. 10. Remove the interior door latch, by gently pulling out on the front corner, which is held in by a plastic compression spring. 11. Remove the Foam Arm Rest bolster, by unclipping the 4 plastic compression clips and the clip fasteners. 12. Remove the 4 Door Speaker screws, and disco ...
Host: www.a1electric.com

 

Download Ford Focus power window installation