ManualSpace

R1200C CHIP INSTALLATION INSTRUCTIONS TOOLS REQUIRED: 1. 3mm Hex key, ball end preferred; 2. 4mm Hex key, ball end preferred; 3. 5mm Hex key, ball end preferred; 4. #2 Phillips head screwdriver, long; 5. Small flat blade screwdriver, NON-MAGNETIC tip; 6. Medium flat blade screwdriver, suitable for use as pry bar; 7. T30 Torx, tamper-proof; 8. Adjustable fuel flow restriction clamps, qty:  2, refer to photo in step 3; 9. Masking tape:  useful for labeling fuel lines, vent hoses, screw locations; 10. Clear RTV silicone; 11. Medium wire ties, qty:  2, for fuel tank vent hoses @ fuel cell; This instruction set provides a basic task list to follow, though presumes mechanical familiarity and confidence in disassembly of the bike.  The following BMW service manual provides more detailed instruction on bike disassembly. R1200 C  01 51 9 799 959 Electrostatic discharge (ESD) mat and wrist ground strap are highly recommended. EXTERIOR DISASSEMBLY 1. Remove both sets of side covers. 2. Remove front seat (2x 5mm Hex). 3. Remove fuel tank.  LESS FUEL IS BETTER. Clamp off the fuel supply and return hoses at the plastic fuel pipes.  These hoses MUST be clamped to avoid substantial fuel loss.  Some late bikes may be equipped with a quick-connect fitting (not shown).  Simply depress the spring and pull fittings apart;  push together to reconnect. - 8926 BROADWAY, STE# 101 * SAN ANTONIO, TX 78217 * V# 210.826.0014* F# 210.822.7808- info@rhinewestperformance.com    www.rhinewestperformance.com 1 CONTROL UNIT REMOVAL 1. The control unit and harness connections should be visible now that the tank has been removed.  Remove the four Phillips head control unit mounting screws, as shown. 2. Pull control unit up and off of the E-box mounting plate.  IF you are using an aftermarket exhaust system, pull off the black pla ...
Host: www.rhinewestperformance.com

 

Download R1200C CHIP INSTALLATION INSTRUCTIONS